xD L4-1.8L (2ZR-FE) (2008)
NOTE: Make sure that the lip portion of hole cover No. 1 is not damaged.
13. INSTALL STEERING SLIDING YOKE SUB-ASSEMBLY
(a) Align the matchmarks and install the sliding yoke onto the intermediate shaft.
Torque: 35 Nm (357 kgf-cm, 26 ft-lbf)
(b) Tighten bolt A.
Torque: 35 Nm (357 kgf-cm, 26 ft-lbf)
14. INSTALL COLUMN HOLE COVER SILENCER SHEET
(a) Install the column hole cover silencer sheet with the 2 clips.
(b) Install the floor carpet.
15. INSTALL OUTER COWL TOP PANEL
16. INSTALL FRONT AIR SHUTTER SEAL RH
17. INSTALL FRONT WIPER MOTOR AND LINK See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation
18. INSTALL COWL TOP VENTILATOR LOUVER LH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation
19. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front
Wiper Motor/Installation
20. INSTALL HOOD TO COWL TOP SEAL See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper Motor/Installation
21. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation
22. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper
Motor/Installation
23. INSTALL FRONT WIPER ARM HEAD CAP See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Front Wiper Motor/Installation
24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 ft-lbf)
25. POSITION FRONT WHEELS FACING STRAIGHT AHEAD
26. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
See: Alignment/Service and Repair/Front Wheel Alignment