xD L4-1.8L (2ZR-FE) (2008)
Axle Beam: Service and Repair
Removal
SUSPENSION: REAR AXLE BEAM: REMOVAL
REMOVAL
1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID
NOTE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.
3. SEPARATE SKID CONTROL SENSOR WIRE See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Coil Spring/Removal
4. SEPARATE REAR BRAKE NO. 4 TUBE
(a) Using a union nut wrench, separate the brake tube from the flexible hose.
(b) Remove the clip and disconnect the flexible hose from the axle beam.
(c) Remove the nut and separate the brake tube.
5. SEPARATE REAR BRAKE NO. 3 TUBE
HINT: The removal procedure for the RH side is the same as that for the LH side.
6. SEPARATE PARKING BRAKE NO. 3 CABLE ASSEMBLY
(a) Break the cable clamp to remove it.
(b) Remove the bolt and separate the parking brake cable.
7. SEPARATE PARKING BRAKE NO. 2 CABLE ASSEMBLY
HINT: The removal procedure for the RH side is the same as that for the LH side.
8. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY See: Brakes and Traction Control/Drum Brake System/Service and Repair/Removal
9. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH See: Wheel Hub/Service and Repair/Rear Axle Hub/Removal
10. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY RH
HINT: The removal procedure for the RH side is the same as that for the LH side.
11. LOOSEN REAR AXLE BEAM See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Coil Spring/Removal
12. REMOVE REAR ABSORBER CAP
13. REMOVE REAR ABSORBER CAP
14. REMOVE REAR SHOCK ABSORBER CAP LH
15. REMOVE REAR SHOCK ABSORBER CAP RH
16. REMOVE REAR SHOCK ABSORBER LH See: Suspension Strut / Shock Absorber/Service and Repair/Rear Shock Absorber/Removal