xD L4-1.8L (2ZR-FE) (2008)
Valve Body: Testing and Inspection
U341E AUTOMATIC TRANSAXLE: VALVE BODY: INSPECTION
INSPECTION
1. INSPECT SHIFT SOLENOID VALVE S1
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
If the value is not as specified, replace the shift solenoid valve S1.
(b) Connect the positive (+) battery lead to the terminal of the solenoid connector, and the negative (-) battery lead to the solenoid body, and check
the operation of the valve.
NOTE: When using the battery during the inspection, do not bring the positive and negative tester probes too close to each other as a short
circuit may occur.
OK:
The solenoid makes an operating sound.
If the operation cannot be done as specified, replace the shift solenoid valve S1.
2. INSPECT SHIFT SOLENOID VALVE S2