xD L4-1.8L (2ZR-FE) (2008)
(a) Install the tie rod end onto the steering knuckle with a new castle nut.
Torque: 49 Nm (500 kgf-cm, 36 ft-lbf)
NOTE: If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.
(b) Install a new cotter pin.
6. INSTALL FRONT STABILIZER LINK ASSEMBLY
(a) Install the stabilizer link with the nut.
Torque: 74 Nm (755 kgf-cm, 55 ft-lbf)
HINT: If the ball joint turns together with the nut, use a socket hexagon wrench 6 to hold the stud.
7. INSTALL FRONT SPEED SENSOR
(a) Install the speed sensor onto the steering knuckle with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTICE:
-
Check that the speed sensor tip and installation portion are free of foreign matter.
-
Install the speed sensor without turning it from its original installation angle.
(b) Install the flexible hose and speed sensor with the bolt.
Torque: 29 Nm (300 kgf-cm, 22 ft-lbf)
NOTE: Install the flexible hose and speed sensor without twisting them.
8. INSTALL FRONT AXLE HUB NUT
(a) Clean the threaded parts on the drive shaft and axle hub nut using a non-residue solvent.
NOTICE:
-
Be sure to perform this work for a new drive shaft.