xD L4-1.8L (2ZR-FE) (2008)
(c) Using a plastic hammer, tap the buckle to fix it while adjusting the clearance between the lever and the groove to make the clearances between
the buckle edge and the lever end even.
NOTE: Do not damage the inboard joint boot.
12. INSTALL FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP
(a) Install the boot clamp onto the inboard joint boot.
(b) Adjust dimension (A) between the centers of the boot clamp and No. 2 boot clamp until it is within the specified length.
Dimension (A):
69.1 to 77.1 mm (2.27 to 3.03 in.)