scion Workshop Repair Guides

Scion Workshop Service and Repair Manuals

Components|Page 4048 > < Components|Page 4046
Page 1
background image

Seals and Gaskets: Service and Repair
Removal

C50 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: REMOVAL

REMOVAL

1. DRAIN TRANSAXLE OIL

(a) Remove the filler plug and the gasket.
(b) Remove the drain plug and gasket, and then drain the manual transaxle oil.
(c) Install a new gasket and the drain plug.

Torque: 39 Nm (400 kgf-cm, 29 ft-lbf)

2. REMOVE FRONT WHEELS
3. REMOVE FRONT AXLE HUB NUT LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal

                 

4. REMOVE FRONT AXLE HUB NUT RH

HINT: The removal procedure for the RH side is the same as that for the LH side.

5. SEPARATE FRONT SPEED SENSOR LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal

                 

6. SEPARATE FRONT SPEED SENSOR RH

HINT: The separation procedure for the RH side is the same as that for the LH side.

7. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service

and Repair/Removal

                 

8. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH

HINT: The separation procedure for the RH side is the same as that for the LH side.

9. SEPARATE TIE ROD END SUB-ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal

                 

10. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT: The separation procedure for the RH side is the same as that for the LH side.

11. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and

Repair/Removal

                 

12. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT: The separation procedure for the RH side is the same as that for the LH side.

13. SEPARATE FRONT AXLE ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal

                 

14. SEPARATE FRONT AXLE ASSEMBLY RH

HINT: The separation procedure for the RH side is the same as that for the LH side.

15. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal

                 

16. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal

                 

Components|Page 4048 > < Components|Page 4046