xD L4-1.8L (2ZR-FE) (2008)
Clutch Pedal Position Sensor / Switch: Service and Repair
Installation
CLUTCH: CLUTCH PEDAL SWITCH: INSTALLATION
INSTALLATION
1. INSTALL CLUTCH START SWITCH ASSEMBLY
(a) Install the clutch start switch with the nut.
Torque: 16 Nm (160 kgf-cm, 12 ft-lbf)
NOTE: Insert the protrusion of the clutch start switch into the hole in the clutch pedal support.
(b) Connect the clutch start switch connector.
2. INSPECT CLUTCH START SWITCH ASSEMBLY See: Testing and Inspection/On-Vehicle Inspection