xD L4-1.8L (2ZR-FE) (2008)
Back Window Glass: Service and Repair
Removal
WINDSHIELD / WINDOWGLASS: BACK DOOR GLASS: REMOVAL
REMOVAL
1. REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Disassembly
2. REMOVE BACK DOOR SIDE GARNISH LH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
3. REMOVE BACK DOOR SIDE GARNISH RH
HINT: Use the same procedure as for the LH side.
4. REMOVE BACK DOOR INSIDE HANDLE See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Disassembly
5. REMOVE BACK DOOR TRIM BOARD ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Disassembly
6. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Rear Wiper
Motor/Removal
7. REMOVE REAR WIPER MOTOR See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Rear Wiper Motor/Removal
8. REMOVE REAR WIPER MOTOR GROMMET See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Rear Wiper Motor/Removal
9. REMOVE REAR SPOILER SUB-ASSEMBLY See: Body and Frame/Spoilers, Flaps, and Air Dams/Spoiler/Service and Repair/Removal
10. REMOVE BACK DOOR WINDOW MOULDING
(a) Using a knife, cut off the back door window moulding, as shown in the illustration.
NOTE: Do not damage the vehicle body with the knife.
(b) Remove the back door window moulding.
HINT: Make a partial cut in the back door window moulding. Then pull and remove it by hand.
11. REMOVE BACK DOOR GLASS