xD L4-1.8L (2ZR-FE) (2008)
Back Window Glass: Service and Repair
Installation
WINDSHIELD / WINDOWGLASS: BACK DOOR GLASS: INSTALLATION
INSTALLATION
1. CLEAN BACK DOOR GLASS
(a) Using a scraper, remove the clips, dam and adhesive sticking to the back door glass.
(b) Clean the outer edge of the back door glass with a non-residue solvent.
NOTICE:
-
Do not touch the back door glass surface after cleaning it.
-
Even if using a new back door glass, clean the back door glass with a non-residue solvent.
HINT: Since the pin is for positioning the glass, there is no need to replace it with a new one when reusing the glass, even if damaged.
2. CLEAN VEHICLE BODY
(a) Clean and shape the contact surface of the vehicle body.
(1) Using a knife, cut away any rough adhesive on the contact surface of the vehicle body to ensure the appropriate surface shape.
NOTE: Do not damage the vehicle body.
HINT: Leave as much adhesive on the vehicle body as possible.
(2) Clean the contact surface of the vehicle body with a shop rag or piece of cloth saturated with cleaner.
HINT: Clean the vehicle body even if all the adhesive has been removed.
3. INSTALL BACK WINDOW GLASS CLIP LH
(a) Apply Primer G to the installation part of the back window glass clip.
HINT: If primer is applied to an area that is not specified, wipe off the primer with a non-residue solvent before it dries.
(b) Install the new clip onto the glass, as shown in the illustration.
NOTICE:
-
Allow the primer to dry for 3 minutes or more.