Leon Mk1
Axle for reverse gear pinion: dismounting an assembling |
Assembly Chart |
1 - | Clutch casing |
2 - | Axial/radial needle bearing |
q | Dismounting → Fig. |
q | After the dismounting, the axial/radial needle bearing must always be replaced. |
q | Assembling → Fig. |
3 - | Reverse gear pinion |
4 - | Safety ring |
q | Use the tool -A-81124- for extracting the safety ring |
q | Always replace |
5 - | Reverse gear moving pinion |
q | Position for assembly: the collar of the pinion must face towards the reverse gear pinion. |
6 - | Axle for reverse gear pinion |
q | Dismounting → Chapter |
7 - | Axial/radial needle bearing |
q | Dismount → Fig. |
q | After the dismounting, the axial/radial needle bearing must always be replaced. |
q | Assembling → Fig. |
8 - | Support for the reverse gear axle |
q | Dismounting and assembling → Chapter |
Special tools and workshop equipment required |
t | Case for extractors for gears -U-40100- |
t | Gearbox repair case -U-40200- |
t | Gearbox repair case -U-40300- |
|
|
|