SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Renewing seal for right flange shaft >
< Seals for flanged shafts: replacement
Leon Mk1
0AF 5-speed manual gearbox
Final drive, differential, differential lock
Seals for flanged shafts: replacement
Renewing seal for right flange shaft
Operation process
Operation process
l
Gearbox must be fitted
–
Remove bolts
-1-
and
- 2-
and remove central soundproofing panel.
–
Unbolt the heat shield for the right hand side wheel driveshaft
-arrows-
.
–
Remove the wheel drive shaft from the flanged shaft
→ Rep. gr.40
.
–
Secure wheel drive shaft above, taking care not to damage surface protection cover.
–
Place below the collecting tray -T20173-.
–
Unscrew securing bolt of right flanged shaft arrow. To do this, screw two bolts into flange and immobilise shaft with a lever.
–
Remove flange shaft along with spring, thrust washer and tapered ring.
–
Remove flanged shaft seal by levering with extractor -T20143/2 -.
Note
t
Do not damage sleeve. Otherwise, leaks will occur.
t
In case of deterioration, replace the sleeve.
–
Lightly lubricate outer edge of new seal.
–
Fill the space between the sealant lip and the dust guard
-arrow-
half way with sealant grease
→ Electronic spare parts catalogue „ETKA“
.
–
Fit new seal as far as it will go using pressure tool -T20133- without tilting it.
–
Secure flanged shaft with conical bolt, using counterhold -T20005 -.
Further installation is carried out in the reverse order, noting the following:
–
Tighten the wheel drive shaft to the flanged shaft
→ Rep. gr.40
–
Oil level for gears: verification
→ Chapter
.
0AF 5-speed manual gearbox
Final drive, differential, differential lock
Seals for flanged shafts: replacement
Renewing seal for right flange shaft
Renewing seal for right flange shaft >
< Seals for flanged shafts: replacement