Leon Mk1
Assembly overview - pedal cluster |
1 - | Mounting bracket |
q | Removing and installing → Chapter |
2 - | Pivot pin for clutch and brake pedal |
q | Installation position: circumferential groove -arrow- is on clutch pedal side. |
3 - | Securing clip |
q | Removing and installing → Anchor |
q | For securing pivot pin for clutch pedal and brake pedal |
4 - | Hexagon bolt, 40 Nm |
5 - | Brake light switch |
q | Removing and installing → Brake system; Rep. Gr.46 |
6 - | Self-locking hexagon nut, 25 Nm |
q | Qty. 5 |
q | For mounting bracket to stud of brake servo and mounting plate to bulkhead |
q | Always renew |
q | Tighten diagonally on brake servo. |
7 - | Bearing bush |
q | Qty. 4 |
q | For mounting clutch pedal and brake pedal |
8 - | Brake pedal |
q | Removing and installing → Brake system; Rep. Gr.46 |
9 - | Cap |
10 - | Bearing bush |
q | To support column tube with steering column |
q | Fitting position: wide collar faces clutch pedal |
11 - | Clutch pedal switch -F36- |
q | Distinguishing → Chapter |
q | Removing, installing and adjusting clutch pedal switch with rectangular housing → Chapter |
q | Removing, installing and adjusting clutch pedal switch with round housing → Chapter |
12 - | Bump stop |
q | For accelerator pedal |
q | Insert into mounting bracket |
13 - | Hexagon bolt, 20 Nm |
q | Qty. 2 |
14 - | Over-centre spring |
q | Removing and installing → Chapter |
15 - | Stop |
q | For clutch pedal |
q | When being pushed on, mounting bracket must engage between locking lugs and seal |
q | Fitting position: flat side faces upwards |
q | Adjusting → Chapter |
16 - | Clutch pedal |
q | Removing and installing → Chapter |
17 - | Retainer |
q | Removing and installing → Item |
18 - | Securing clip |
q | Removing and installing → Anchor |
q | For securing pivot pin for clutch pedal and brake pedal |
19 - | Clip |
q | For securing pipe/hose line on master cylinder |
20 - | Bolt, 10 Nm |
q | For master cylinder on mounting bracket |
21 - | Seal |
q | Always renew |
22 - | Supply hose |
q | Rubber |
q | From 12.05, plastic in some vehicles → Fig. |
23 - | Master cylinder |
q | Removing and installing → Chapter |