SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Installing >
< Removing and installing clutch pedal
Leon Mk1
6-speed manual gearbox 02N
Clutch, control
Repairing clutch mechanism / moving_and_installing_clutch_pedal/">Removing and installing clutch pedal
Removing
Removing
Removing
–
Clamp off supply hose
-A-
to brake fluid reservoir with hose clamp -3094-.
–
Connect bleeder hose
-A-
from receptacle bottle of brake filling and bleeding device -V.A.G 1869- or -VAS 5234- and open bleeder valve
-arrow-
of slave cylinder.
–
Remove covers on driver side
→ General body repairs, interior; Rep. Gr.68
.
–
Unhook relay plate from both retainers, unscrew upper fastener and tie up relay plate
→ Electrical system; Rep. Gr.97
.
–
Remove cover from mounting bracket
-arrow 1-
and
-arrow 2-
.
–
Remove clutch pedal switch -F36-
→ Item
.
–
Remove over-centre spring
→ Chapter
.
Release master cylinder operating rod from clutch pedal as follows:
–
Insert pliers -T10005- into opening for operating rod mounting.
–
Press sides of retainer inwards
-arrows-
using pliers -T10005-.
–
Pull clutch pedal gently into passenger compartment.
–
Remove operating rod with retainer from pedal and push into engine compartment to stop.
–
Remove left securing clip from pivot pin.
To do this, lever tab in
-direction of arrow 1-
with a screwdriver and press in
-direction of arrow 2-
.
–
Remove right securing clip for pivot pin on brake pedal side towards dash panel
-arrow A-
.
To do this, guide in screwdriver
-C-
so that it goes under tab
-B-
.
–
Pull clutch and brake pedal pivot pin to right until clutch pedal can be pulled off.
–
Remove clutch pedal.
6-speed manual gearbox 02N
Clutch, control
Repairing clutch mechanism / moving_and_installing_clutch_pedal/">Removing and installing clutch pedal
Removing
Installing >
< Removing and installing clutch pedal