SEAT Workshop Service and Repair Manuals > Leon Mk1 > 6-speed manual gearbox 02Q, all-wheel drive | Clutch, control | Clutch release assembly, clutch slave cylinder: repairs

Removing and installing pipe and hose assembly on the slave cylinder

Remove pipe and hose assembly in clutch slave cylinder

–	To remove, the release the safety fastener -2- with a screwdriver then unscrew and disconnect the air bleeder valve -4- from the slave cylinder -1-.

Note

When removing the hose assembly or master cylinder, use the hydraulic seal adapters to avoid liquid leaking onto the bodywork.

–	For installation a new O-ring -3- must be fitted to the slave cylinder. Insert the air bleeder valve into the slave cylinder connection until the attachment clip is connected with an audible click.

–	Check by pulling on bleeder.

Removing and fitting the air bleeder valve on the slave cylinder

–	To remove, the release the safety fastener -2- with a screwdriver then unscrew and disconnect the air bleeder valve -4- from the slave cylinder -1-.

–	For installation a new O-ring -3- must be fitted to the slave cylinder. Insert the air bleeder valve into the slave cylinder connection until the attachment clip is connected with an audible click.

SEAT Workshop Service and Repair Manuals