SEAT Workshop Service and Repair Manuals

Operation process l  Gearbox must be installed –  Remove front left-hand wheel.

–  Remove central noise insulation -Fasteners 1 ... 3-. –  Unbolt the driveshaft from the gearbox flange.

–  Remove noise insulation → Rep. gr.66. –  Remove left drive shaft → Rep. gr.40.

–  Fit the tray -T20173- beneath gearbox to collect the oil. –  Unscrew the bolt securing the left flanged shaft using the spanner -T20203 -; to do this, screw two bolts into the flange and immobilise the shaft with a lever. –  Pull out the flanged shaft.

–  Extract the flanged shaft seal using the adapter -T20143/2 -. –  Lightly lubricate outer edge of new seal.

–  Fill space between sealing lip and dustcap -arrow-, halfway, with sealing grease → Spare parts catalogue.

–  Fit the new seal until it reaches the limit without leaning it on the tube element -T10088-. –  Press the flanged shaft against the gearbox housing and screw it in. Tightening torque → Item Rest of installation is carried out in the reverse sequence, observing the following: –  Fit the left hand side wheel drive shaft → Rep. gr.40. –  Add gear oil to the manual gearbox and check the oil level → Chapter. Tightening torques:

Component		Nm
Flanged shaft to differential		25 → Item