–
| Unscrew the oil level test bolt for gears -arrow-. |
Oil level is correct when gearbox is filled to lower edge of filler hole. |
–
| Install bolt -arrow- with new seal and tighten to 45 Nm. |
If the container must be completely filled with oil, note the following: |
–
| Remove the bolt -arrow-. |
–
| Fill with gear oil to lower edge of filler hole. |
–
| Install bolt -arrow- with new seal and tighten to 45 Nm. |
–
| If present, attach noise insulation to gearbox. |
–
| Install noise insulation below engine and gearbox. |
|
|
|