SEAT Workshop Service and Repair Manuals

The basic setting should be initiated after performing the following repairs:

• ◆ Exchanging engine
• ◆ Replacing or coding engine control unit
• ◆ Removing and installing gearbox
• ◆ Removing and installing "electronic accelerator"
• ◆ Altering throttle valve
• ◆ Adjusting throttle valve (setting idling speed).
• ◆ Replacing throttle valve potentiometer -G69-
• ◆ Altering throttle valve potentiometer -G69- setting e.g. when adjusting idling switch (engine)
• ◆ Replacing automatic gearbox control unit -J217-

• ‒ Connect fault reader V.A.G 1551 and enter address word "02 Gearbox electronics" and advance until "Select function XX" appears in the display => from page 01-31.

• ‒ Press keys 0 and 4. (The function "Initiating basic setting" is selected with 04).

Accelerator pedal must remain in idling position.

• ‒ Confirm entry with key Q.

• ‒ Press key 0, 0 and 0.
• ‒ Confirm entry with key Q.

The system is now in the basic setting.

• ‒ Depress accelerator pedal as far as kickdown and hold in this position for 3 seconds.
• ‒ Press key ⇒.