SEAT Workshop Service and Repair Manuals

Conditions for performing check

• ● Gearbox not emergency running, ATF temperature not above approx. 30°C
• ● Vehicle level
• ● Selector lever at "P"

• ‒ Remove noise insulation tray.
• ‒ → Secure reservoir of ATF filling system V.A.G 1924 to vehicle.
• ‒ Connect fault reader V.A.G 1551 and enter address word "02 Gearbox electronics" and advance until "Select function XX" is indicated on display.

=> Repair group 01; Performing self-diagnosis; Connecting fault reader V.A.G 1551 and selecting function

• ‒ Start engine.
• ‒ Raise vehicle.
• ‒ Place container under the gearbox.

• ‒ Press keys 0 and 8. (The function "Read measured value block" is selected with 08.)

• ‒ Confirm entry with key Q.

• ‒ Press keys 0 0 5. (005 selects the "Display group number 005".)
• ‒ Confirm entry with key Q.

The first display zone shows the ATF temperature.

• ‒ Bring ATF to test temperature.

Test temperature: 35 °C to 45 °C

• ‒ → Remove ATF level plug from the oil pan.

→ The ATF present in the overflow pipe (arrow 2) runs out.

ATF drips out of drilling:

ATF need not be topped up.

• ‒ Fit new seal (arrow 1) to plug and tighten to 15 Nm. Herewith is the ATF check completed.

Sealing plug (arrow 3) and cap (arrow 4) remain closed.

If only the ATF present in the overflow pipe runs out of drilling: