Leon Mk1
|
Note
|
|
| Carry out following work: |
| – | Remove front wheel housing liner → Chapter. |
| – | Remove turn signal repeater → Electrical system; Rep. gr.94. |
| – | Remove front bumper lining → Chapter. |
| – | Remove front lateral guide profile -5- for the bumper lining → Item. |
| – | Removing plenum chamber cover → Chapter. |
| – | Pull out insulation for rib section → Item. |
| – | Unscrew bolts -2 and 6-. |
| – | Remove wing -1- carefully. |
|
Note| Install wing -1- without subjecting it to tensile stress. |
| Carry out following work: |
| Installation of the wing -1- is carried out in reverse order of removal. |
| – | Wing is aligned free of stress with wing bracket loosened → Chapter. |
| – | Always insert zinc intermediate piece -AKL 381 035 50- between wing and side member. |
| – | Specified torques for bolts -2 and 6- → Chapter. |
| – | Ensure joints are parallel and shut lines are equal → Rep. gr.00. |
