Leon Mk1
| Installation |
Note| t | Install wing -1- without subjecting it to tensile stress. |
| t | Particular care must be taken when tightening bolt -6-. |
| t | Bolt -6- and the tool must not be allowed to hit the windscreen. |
| Carry out the following work: |
| Installation is carried out in reverse order. |
| – | Always insert zinc intermediate piece -AKL 381 035 50- between wing and side member. |
| – | Tightening torque of the screws -2-: 6 Nm. |
| – | Tightening torque bolts -6-: 4 Nm |
| – | Take care that these are parallel with each other and that the gap is maintained: → Rep. gr.00 |
