Leon Mk1
Installation |
– | Remove any adhesive residue with adhesive strip remover -VAS 6349-. |
– | Clean bonding surfaces -5- on rear part and guide rails with cleaning solution -D 009 401 04-. |
– | Insert a Ø 3.5 mm butyl sealing cord -AKD 497 010 04 R10--5- into bonding channel on rear section -1- as shown. |
– | Push entire rear part -1- with discharge tubes -2- in direction of -arrow- onto guide rails -3-. |
– | Tighten bolts -2- to tightening torque 2 Nm. |
Note
Before installation, check assembly frame for leaks. |
– | Seal water drain fitting -3-. |
– | Fill marked area -4- between rear section -2- and guide rail -5- with water. |
– | Wait for at least 5 minutes and then check for leaks. |
– | Seal any leaks with butyl sealing cord -AKD 497 010 04 R10-. |
– | Install sun blind → Chapter. |
– | Install sun blind motor → Chapter. |
– | Install new interior seal → Chapter. |
– | Install assembly frame → Chapter. |
– | On completion of all work, carry out a normalisation run for all panoramic sliding roof drives → Chapter. |