1 - | Glass scraper (commercially available) |
2 - | Blade (commercially available) |
–
| Remove retaining plate from mirror base. |
–
| Remove PUR adhesive sealant from retaining plate using a wire brush. |
–
| Grind off the three spacer protrusions on bonding surface. To do this, use sandpaper (360/400 grain) laid on flat surface. |
–
| Keep sanded surface clean and free of grease. |
–
| Scrape down PUR adhesive sealant and glass/paint primer down to ceramic layer on windscreen using glass scraper. |
–
| Clean bonding area with adhesive remover D 002 000 10 or cleaning solution D 009 401 04. |
WARNING Do not damage ceramic coating. Scratches will remain permanently visible. |
|
–
| Cut nylon mesh fabric exactly to size of retaining plate. |
Note Wear hand protection (rubber gloves). |
–
| Apply adhesive evenly to retaining plate. |
–
| Place nylon mesh fabric on retaining plate. |
–
| Dab nylon mesh fabric with tube while applying further adhesive. |
Only 30 seconds are available from laying nylon mesh fabric on adhesive to pressing plate onto windscreen. |
–
| Press retaining plate (do not use force) against windscreen for 15 seconds. |
–
| Remove excess adhesive with a cloth. |
Note Interior mirror can be installed after 15 minutes. |
|
|
|