Leon Mk1
|
|
|
– | Remove interior trim -1- using the lever -U 30800-. |
– | Detach loudspeaker grille -13-using lever -U 30800-. |
– | Detach lining cover in the door -14- using the lever -U 30800-. |
– | Remove connector for electric window lifters switch. |
– | Unscrew the screws -12- (2x). |
– | Detach the upholstery of the trim -11- using removal pliers -T20065-, starting with the upper part. |
– | Disengage operating cable -5- from trim upholstery -11- → Fig.. |
– | Unscrew the screws -3- (4x) of the loudspeaker -4-. |
– | Remove the loudspeaker -4-and disconnect the connector. |
– | Remove the cover -10-, by levering. |
– | Lower the door window until bolts and expansion plugs of the window cavity can be accessed, and |
– | Turn off the ignition and all electricity consumers. |
– | With the ignition switched off, disconnect the earth lead from the battery → Starter motor, voltage supply; Rep. gr.27. |
– | Remove the expanding pins and the window lifter from the guide -T20087-. |
– | Remove window glass → Body, exterior assembly work ; Rep. gr.64. |
– | Loosen bolts -6- (3x), disconnect window riser unit connector -7- and remove. |
– | Unscrew the screws -8- (2x). |
– | Unscrew the screws -2- (2x). |
– | Unscrew the screws -16- (2x). |
– | Remove exterior door lining assembly → Fig. |
– | Remove window frame → Fig. |
– | Remove front trim of the rear door -9- by raising it and extracting it towards the door hinge side. |
– | Turn the rear panel lining over and disconnect the door lock connector. |
– | Remove the window riser unit from the rear panel lining. |
– | Finally, unhook the clips of the electrical cables in the rear part of the rear door panel lining. |
Note
|
|
|
|