Leon Mk1
| Assembly overview - rear bumper |
| 1 - | Cover |
| q | Material: PP/EPDM |
| q | Removal: |
| – | Remove Torx screws -5-. |
| – | Remove Torx screws -3-. |
| – | Remove hexagon nuts -9-. |
| – | Pull bumper off guides -10- (left and right-hand sides). |
| – | To remove, unclip bumper at upper edge from guides -10-. |
| 2 - | Bumper strip |
| q | Clipped into cover. only remove after bumper has been disassembled. |
| q | Models from 11.03 have chrome strip. |
| q | Only remove chrome strip after bumper has been removed. |
| 3 - | Torx screw |
| q | Hidden by trim -13-. |
| q | Specified torque: 7 Nm |
| 4 - | Speed nut |
| 5 - | Torx screw |
| q | Connects cover to wheel housing liner. |
| 6 - | Hexagon nut |
| q | Specified torque: 15 Nm |
| 7 - | Bumper carrier |
| 8 - | Torx screw |
| 9 - | Hexagon nut |
| q | 15 Nm |
| 10 - | Guide |
| q | To remove, unclip bumper from guides. |
| 11 - | Spreader clip |
| 12 - | Grommet |
| 13 - | Trim |
| q | Removal: |
| – | Begin by unclipping from the rear lid. |
