Leon Mk1
Assembly overview - rear bumper |
Note
With vehicles with towing brackets, the cover must be cut out. The size of the cut-out is shown on the inner side of the cover. |
1 - | Cover |
q | Material: PP/EPDM |
q | Removal: |
– | Remove Torx screws -5-. |
– | Remove hexagon nuts -9-. |
– | Pull bumper off guides -10- (left and right-hand sides). |
– | Renew any broken retainers → Chapter. |
2 - | Cover |
q | For vehicles with towing bracket. |
3 - | Washer |
4 - | Cross-head screw |
5 - | Torx screw |
q | Connects cover to wheel housing liner. |
6 - | Impact absorber |
7 - | Deformable element |
8 - | Hexagon bolt |
9 - | Hexagon nut |
q | Specified torque: 15 Nm |
10 - | Guide |
q | To remove/install bumper, pull out or push in parallel to guides at left and right. |
11 - | Spreader clip |
12 - | Grommet |
13 - | Retainer for cover |