Leon Mk1
Front wing, removing and installing |
1 - | Wing |
q | Removing: |
– | Remove the front bumper and its reinforcement → Chapter. |
– | Removing the wheel housing moulding → Chapter |
– | Remove the separation element → Chapter. |
– | Heat the side of front wing by the side of strut A with the electric blower -SAT 1416- and extract it (separate the underbody protector -KR00430603- or underbody protector -0000980603- with the aid of an upholstery knife). |
Note
t | The underbody protector -KR00430603- or underbody protector -0000980603- can only be heated slightly, and for a short period. The PVC should not change colour or form bubbles. |
t | When supporting any part between the front wing and the surface over which it is supported, use appropriate material to protect the wing. |
q | Installation |
– | Before screwing the front wing an intermediate coating of electroweldable zinc paint -KR00430903- or electroweldable zinc paint -0000980903- must be applied to the zone in contact with the screws. |
– | Place the underbody protector -KR00430603- or underbody protector -0000980603- on the zones that had been separated by the protector using the structural putty pistol -SAT 5380-. |
2 - | Bolt |
q | Eleven units |
q | Tightening torque: 8 Nm |
3 - | Elastic nut |
4 - | Joint |
5 - | Support |
q | Is fixed to the front beam with screws |