Leon Mk1
Lock carrier plate and mobile elements: removing and fitting |
1 - | Lock carrier with moving components |
q | Removing |
– | Remove the lower engine noise insulation → Item. |
– | Unhook the Bowden cable → Item from the lock and disconnect the electric connectors. |
– | Remove the right and left headlamps → Headlamps: removing and fitting; Rep. Gr.94. |
– | Remove the front bumper and its reinforcement → Chapter. |
– | Separate the intercooler hoses (according to versions) |
– | Separate the T shaped distributor from the lamp washer flexible tube. |
– | Remove the screws which secure the radiator and condenser assembly to the lock carrier plate → Chapter |
– | Attach the radiator and the condensor to the engine compartment → Air conditioning and heating: engine compartment; Rep. Gr.87. |
Note
Do not hang the condenser from the hoses, and do not fold hoses. |
q | Installation: |
– | Centre the lock carrier plate along the beams between the wings. |
q | Tolerances → Dimensions; Rep. Gr.00. |
– | Re-adjust headlights. |
2 - | Bolt |
q | Four units |
q | Tightening torque: 8 Nm |
3 - | Bowden Cable |
4 - | Radiator and condenser |
5 - | Bolt |
q | Four units |
q | Tightening torque: 8 Nm |
6 - | Bumper support |
7 - | Bolt |
q | Four units |
q | Tightening torque: 50 Nm |