Leon Mk1
General assembly overview |
1 - | Bumper lining |
q | Material: PP/EPDM |
q | Removing |
– | Remove the fixing bolts → Itemwhich secure bumper → Item lining to underbody lining → Chapter. |
– | Unscrew the bolts → Item that secure the bumper lining → Item to the wheel housing moulding → Item: → Chapter |
– | Remove lock plate lining → Linings of rear bonnet ; Rep. Gr.70. |
– | Remove side boot lining partially → Boot linings; Rep. Gr.70 |
– | Unscrew the bolts → Item that secure the bumper lining → Item to the locking plate. |
q | Tightening torque: 6.6 Nm |
2 - | Bumper moulding |
q | Clipped to the lining |
q | Removal causes imperfections |
3 - | Bolt |
– | Unscrew → Chapter |
q | Tightening torque: 1.5 Nm |
4 - | Stopper |
5 - | Bumper beam |
6 - | Bolt |
q | 2 units |
q | Tightening torque: 6.6 Nm |
7 - | Bolt |
– | Unscrew → Chapter |
q | Tightening torque: 1.5 Nm |
8 - | Beam fastening nut |
q | 4 units |
q | Tightening torque: 23 Nm |
9 - | Wheel housing moulding |
q | PP/EPDM Material |
10 - | Stopper |
11 - | Fixed guide for bumper lining |
12 - | Blind rivet |
q | 4 units |
13 - | Rivet |
q | 4 units |
14 - | Moulding |
15 - | Stopper |
16 - | Moulding securing bolt |
q | 4 units |
q | Tightening torque: 1.5 Nm |