Leon Mk1
| Strut A upper lining: removing and fitting |
| General assembly overview |
| 1 - | Upper lining of strut A |
| 2 - | Bolt |
| 3 - | Double sided adhesive tape |
| 4 - | Clip |
| Removing |
| – | Remove the sunshades and the front handgrips and |
| – | lower the front section of the moulded ceiling |
| – | Remove the bolt → Item |
| – | Detach the lining → Item of strut A and unclip the lower section → Item |
| Installation |
| Installation is carried out in reverse order. The following should be taken into account: |
Note| Before fitting lining → Item check condition of clips → Item and replace if necessary. |
| After removing replace the adhesive tape → Item |
