SEAT Workshop Service and Repair Manuals

Special tools, testers and auxiliary items

• ◆ Counter-hold tool 3099
• ◆ Oil seal extractor 2085
• ◆ Oil seal fitting tool 3083

Removing

• ‒ Remove ribbed belt .
• ‒ Remove toothed belt => Page 13-17.
• ‒ Remove crankshaft sprocket. To do this counter-hold sprocket with 3099.

• ‒ → To guide the oil seal extractor, screw bolt from 3083 into crankshaft as far as it will go.
• ‒ Unscrew inner part of the oil seal extractor 2085 two turns (approx. 3 mm) out of the outer part and lock with knurled screw.

• ‒ → Lubricate threaded head of oil seal extractor, place it in position and exerting firm pressure screw it as far as possible into oil seal.
• ‒ Loosen knurled screw and turn inner part against crankshaft until the oil seal is pulled out.

Installing

• ‒ Lightly oil sealing lip of oil seal.

• ‒ → Place guide sleeve from 3083 onto crankshaft journal.
• ‒ Slide oil seal over guide sleeve.

• ‒ → Press oil seal in onto stop with press sleeve from 3083.
• ‒ Install and tension toothed belt => Page 13-17