- Bearing shells 1, 2, 4 and 5
-
◆ For bearing caps 1, 2 and 5 without oil groove
-
◆ For bearing cap 4 and cylinder block with oil groove
-
◆ Do not interchange used bearing shells (mark)
- 65 Nm + 1/4turn (90 °) further
-
◆ To measure radial clearance tighten to 65 Nm but not further
- Bearing cap
-
◆ Bearing cap 1: Pulley end
-
◆ Bearing cap 3 with recesses for thrust washers
-
◆ Bearing shell retaining lugs (cylinder block/bearing cap) must be on the same side
|