SEAT Workshop Service and Repair Manuals

• Seal
• ◆ Renew
• Connector
• ◆ Black, 6-pin
• ◆ Contacts gold plated
• ◆ For Lambda probe 1 before catalyst (G39) and Lambda probe heater (Z19)
• Lambda probe 1 before catalyst (G39)*, 50Nm
• ◆ Constantly operating Lambda probe
• ◆ Grease only the threads with "G 052 112 A3"; "G 052 112 A3" must not get into the slots on the probe body
• ◆ Remove and install with Lambda probe open ring spanner set 3337
• ◆ Checking:

=> Repair group 24; Checking functions; Checking Lambda probe and Lambda regulation before catalyst

• 25 Nm
• ◆ Renew
• Union, 35 Nm
• ◆ For secondary air injection connecting pipe =>Page 26-9
• Union, 35 Nm
• ◆ For exhaust gas recirculation connecting pipe =>Page 26-18
• Exhaust manifold
• Gasket
• ◆ Renew
• 40 Nm
• ◆ Renew
• Front exhaust pipe
• Hexagon bolt

• Connector
• ◆ Black, 4-pin
• ◆ Contacts 3 and 4 gold-plated
• ◆ For Lambda probe 2 after catalyst (G130) and Lambda probe heating (Z29)
• Lambda probe 2 after catalyst (G130)*, 50 Nm
• ◆ Grease only the threads with "G 052 112 A3"; "G 052 112 A3" must not get into the slots on the probe body
• ◆ Remove and install with Lambda probe open ring spanner set 3337
• ◆ Checking:

=> Repair group 24; Checking functions; Checking Lambda probe and Lambda regulation after catalyst

• To front silencer

• Catalyst
• ◆ If part is renewed, you must interrogate and erase fault memory:

=> Repair Group 01; Fault memory; Interrogating and erasing engine control unit fault memory

• Heat shield
• 10 Nm
• Retaining clip
• 25 Nm
• 40 Nm
• Support