General to self-diagnosis
Technical data of self-diagnosis
Control unit identification
The control unit version is displayed when the fault reader V.A.G 1551, the vehicle system tester V.A.G 1552 or the new tester VAS 5051 is connected and engine electronics control unit selected .
Equipment
Engine code
|
ATM
|
System designation
|
|
Motronic ME7.5
|
Self-diagnosis
|
OBD
|
Final control diagnosis
|
yes
|
Operating mode of data transfer to V.A.G 1551/1552
|
Rapid data transfer
|
Fault memory
|
Non-volatile memory1)
|
Adaption values for throttle valve control part and exhaust gas recirculation valve
|
Non-volatile memory1)
|
Memory for learnt values
|
Volatile memory2)
|
Lambda control
|
2 probes
|
Knock control
|
2 knock sensors
|
Twin-path intake manifold
|
no
|
Variable valve timing
|
no
|
Exhaust gas recirculation system
|
yes
|
Secondary air system
|
yes
|
1) Independent of voltage supply.
2) Values are erased when voltage supply is interrupted.
Functions which can be selected when using the fault readers V.A.G 1551/1552 or VAS 5051
The prerequisites to select the desired functions can be found in the following table.
|
---|
Function
|
Prerequisite
|
Functions on V.A.G 1551/1552 or on VAS 5051
|
Engine stationary, ignition switched on
|
Engine running at idling speed
|
Vehicle being driven
|
01
|
Interrogate control unit version
|
yes
|
yes
|
yes
|
02
|
Interrogate fault memory
|
yes1)
|
yes
|
yes
|
03
|
Final control diagnosis
|
yes
|
no
|
no
|
04
|
Basic setting2)
|
yes
|
yes
|
yes
|
05
|
Erase fault memory
|
yes
|
yes
|
yes
|
06
|
End output
|
yes
|
yes
|
yes
|
08
|
Read measured value block
|
yes
|
yes
|
yes
|
10
|
Adapting
|
yes
|
no
|
no
|
11
|
Login procedure
|
yes
|
no
|
no
|
1) Only carry out with ignition switched on, when engine does not start (operate starter for at least 6 seconds first).
2) Must be carried out after performing the following work: Replacing engine control unit, throttle valve control part, exhaust gas recirculation valve or engine.
|