Leon Mk1
Note
|
| 1 - | Dash panel |
| q | Removing and installing → Rep. Gr.70 |
| q | Removing and installing air ducts and vents → Chapter, Repairing heating |
| 2 - | Dust and pollen filter |
| q | Removing and installing → Chapter |
| 3 - | Filter housing |
| q | Replacing → Chapter. |
| q | Removing and installing → Chapter |
| 4 - | Vacuum unit for fresh air and air recirculation flap |
| q | Ventilated: fresh air operation |
| q | Vacuum hose connection diagram → Chapter |
| q | Removing → Rep. Gr.70 |
| 5 - | Air intake duct* |
| q | With fresh air and air recirculation flap |
| 6 - | Fresh air blower -V2- |
| q | To renew: remove stowage compartment on the front passenger side → Rep. Gr.68. |
| 7 - | Fresh air blower series resistor with overheating fuse -N24- |
| q | To renew: remove stowage compartment on the front passenger side → Rep. Gr.68. |
| 8 - | Trim for air conditioning system controls |
| 9 - | Evaporator housing* |
| q | With evaporator |
| 10 - | Air conditioning system controls |
| q | With built-in air conditioning system switch -E30- |
| q | Installing and adjusting cables → Chapter |
| q | Dismantling and assembling → Chapter |
| 11 - | Heater and air conditioning unit* |
| q | With evaporator |
| q | With temperature flap |
| q | With centre flap |
| q | With footwell/defroster flap |
| q | Removing and installing → Chapter |
| q | Dismantling and assembling → Chapter |
| 12 - | Water drain pipe* |
| 13 - | Seal* |
| 14 - | Connection housing for vacuum hoses |
| q | With interchange protection |
| q | In fresh air and air recirculation switch -E184- |
| q | Vacuum hose connection diagram → Chapter |
| 15 - | Arrow points in direction of vacuum |
| 16 - | Non-return valve* |
| q | Permits air flow in direction of vacuum, blocked in opposite direction |
| q | Removing: first remove dash panel -1-, cross member and heating. |
| 17 - | Cable for air distribution housing |
| q | Identification: a black securing clip on sheath |
| q | Cables adjust themselves automatically after knobs are turned from stop to stop. |
| 18 - | Temperature flap cable |
| q | Identification: a brown securing clip on sheath |
| q | Cables adjust themselves automatically after knobs are turned from stop to stop. |
| 19 - | Heat exchanger* |
| q | Seals must be bonded free of gaps all around |
| q | If tabs do not engage when inserted or if they have broken off, bolt on heat exchanger. |
| q | After removal, completely renew coolant → Rep. Gr.19. |
| 20 - | Relay carrier |
| q | With air conditioning system delay relay -J70-; control number 168; in brown slot; delays the engaging of air conditioning system magnetic clutch -N25- for 8 seconds to make starting the engine easier. |
| q | With air conditioning system switch-off relay -J365-; control number 147; in yellow slot; disengages air conditioning system magnetic clutch -N25- for kick-down or at full load. |
| q | With cut-out relay for air conditioning system magnetic clutch -J246-; control number 94; in yellow slot. The engine control unit switches off the air conditioning system magnetic clutch -N25- via the relay for 8 seconds when vehicle pulls away from start or under powerful acceleration. |
| q | With radiator fan control unit -J293- (note spare part number) |
