Leon Mk1
1 - | Twelve-sided nut |
q | 20 Nm |
q | Tighten and loosen diagonally in several stages |
2 - | Flywheel |
q | Check that the centring pins are correctly seated |
q | The contact surfaces with the clutch plate must be free from grease and without grooves |
q | Removing and fitting the flywheel → 4 cyl. diesel engine, mechanical; Rep. Gr.13. |
3 - | Clutch plate |
q | Centring → Chapter |
q | Diameter: → Chapter, Code letters, group numbers, ratios, filling quantities |
4 - | Clutch pushrod |
q | Greased in the area where the guide bush of the input shaft is fitted |
q | Assembly position: conical side towards the clutch plate |
5 - | Retaining circlip |
6 - | Clutch release lever |
q | Apply a very thin coating of -G 000 100- grease on the support surface and the clutch pushrod housing |
q | Check that the pushrod housing is not deformed |
7 - | Bolt securing the clutch press to the crankshaft |
q | 60 Nm + 1/4 turn (90°) |
q | Always renew |
8 - | Intermediate plate |
q | Installation position → Chapter |
9 - | Clutch press |
q | Maximum internal deformation of the clutch press: 0.2 mm |
q | Replace the rivetted joint if it is damaged or loose |
q | Removing and installing → 4 cyl. diesel engine, mechanical; Rep. Gr.13 |