Leon Mk1
|
|
|
Note!
Lubricate all points of support and sliding surfaces with grease -G 052 142 A2-. |
1 - | Gear stick knob |
q | Removal and fitting with the cover → Chapter |
2 - | Attachment bush |
3 - | Clip |
q | To attach the knob to the gear stick: |
q | Always renew |
q | To tighten the clamp one can also use the -T20072- tool |
4 - | Casing |
q | Remove and fit together with the stick knob → Chapter |
5 - | Frame |
q | Remove from the central console pulling upwards |
6 - | Bearing bush for control rod |
q | Made up of several components |
q | It is broken on disassembly |
q | On fitting make sure that the plastic components do not separate |
7 - | Control rod |
q | Remove it together with the gear stick, from the protective cover → Fig. |
8 - | Gear stick |
q | Before removing, remove the excentric adjuster → Fig. |
q | Remove from the protective cover together with the gear stick → Fig. |
q | Adjusting the gearbox after assembly → Chapter |
9 - | Plastic ring |
q | Fit on the excentric adjuster groove |
10 - | Excentric adjuster |
q | Fit onto the gear stick after fitting the stick |
q | Remove → Fig. |
11 - | Bolt |
q | 2 Nm |
q | To secure the excentric adjuster |
12 - | Securing pin |
q | Removing and installing → Fig. |
13 - | O-ring |
14 - | Plastic washer |
15 - | Hexagon nut |
q | 10 Nm |
q | Self-locking |
q | Always renew |
16 - | Locking tab |
q | Installation position → Fig. |
17 - | Spring |
18 - | Ball |
q | Replace together with the ball support box |
19 - | Spacer |
20 - | Ball support box |
q | Renew together with the ball |
21 - | Gasket |
q | For the ball support box |
q | Renew if damaged |
22 - | Rivet |
q | To secure the stop |
23 - | Stop |
24 - | Plastic nut |
q | To secure the central console to the gear stick protective cover |
25 - | Spacer |
q | To secure the central console to the gearbox protective cover |
26 - | Self-adhesive gasket |
q | Stick to gear stick protective cover |
27 - | Gear stick protective cover |
q | Removing and fitting → Chapter, Gear drive mechanism: removing and installing |
28 - | Heat shield |
29 - | Hexagon bolt |
q | 20 Nm |
q | To secure the protective cover to the bodywork |
30 - | Cross beam |
31 - | Hexagon nut |
q | 20 Nm |
q | Self-locking |
q | Always renew |
|
|
|