–
| Immobilise the stabiliser bar as shown in the illustration with a flat spanner (e/c 24/27) -1-. |
Note! The spanner must be centred with the counterweight of the stabiliser bar, and perpendicular to the stabiliser bar. |
–
| Loosen the fixing bolt -2- of the counterweight. |
Note! The fixing bolt -2- of the counterweight only needs to be loosened, not removed completely. |
–
| Unbolt the axle support -3- of the engine block and remove it along with the stabiliser bar. |
–
| Place the axle support on a clean surface. |
–
| Remove the fixing bolt of the counterweight. |
–
| Remove the counterweight and the pinion of the stabiliser bar. |
–
| Turn the stabiliser bar unit it can be removed from its housing. |
|
|
|