Leon Mk1
Injector-pump unit: repairing |
t | Observe the Cleaning rules → Chapter |
t | Always replace the seals and O-rings |
1 - | 20 Nm and retighten 1/4 turn (90°) |
2 - | Rocker shaft |
q | With rockers |
q | Remove and install → Chapter, Injector-pump unit: disassembly and assembly |
3 - | Lock nut |
4 - | Adjustment bolt |
q | Replace in case of installing a new injector-pump unit, or if worn |
q | Apply -G 000 100- to the contact surface with the round-headed pin of the injectorpump unit |
5 - | Injector-pump unit |
q | Check the round-headed pin for wear; replace it if necessary |
q | Apply -G 000 100- to the contact surface with the adjustment bolt |
q | Remove and install → Chapter |
6 - | O-ring |
q | Replace → Chapter |
7 - | O-ring |
q | Replace → Chapter |
8 - | O-ring |
q | Replace → Chapter |
9 - | Heat shield seal |
q | Replace |
10 - | Safety washer |
11 - | Cylinder head |
12 - | Fixing block |
13 - | 12 Nm + 3/4 turn (270°) |
q | Replace |