seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
O-rings for injector-pump unit: disassembly and assembly|Installation > < O-rings for injector-pump unit: disassembly and assembly|Remove

Leon Mk1

Assembly
Assembly
  Note!
t  Always use the sleeves for fitting the O-rings. If they are not used, the Orings may be damaged.
t  Make sure that the O-rings are seated in the injector-pump unit without twisting.
–  Remove the heat shield seal along with the safety washer.
–  Carefully clean the O-rings support surfaces in the injector-pump unit.
   
–  Fit assembly sleeve -T10056/1- all the way over the injector-pump unit.
–  Carefully slide the upper O-ring over the assembly sleeve and into its seating on the injector-pump unit.
–  Remove the assembly sleeve.
  N23-0313
–  Fit assembly sleeve -T10056/2- all the way over the injector-pump unit.
–  Carefully slide the middle O-ring over the assembly sleeve and into its seating on the injector-pump unit.
–  Remove the assembly sleeve.
  N23-0314
–  Fit the assembly sleeve -T10056/3- all way over the injector-pump unit.
–  Carefully slide the lower O-ring over the assembly sleeve and into its seating on the injector-pump unit.
–  Remove the assembly sleeve.
–  Fit a new heat shield sleeve along with the safety washer.
  N23-0315

O-rings for injector-pump unit: disassembly and assembly|Installation > < O-rings for injector-pump unit: disassembly and assembly|Remove