If testing and measurement apparatuses are to be used during a road test, the following must be taken into account: |
t
| Always install test and measurement equipment in the rear seat to be operated from there by a second mechanic. |
If test or measurement equipment is operated from the front passenger seat, the operator could be injured by the airbag in the event of an accident. |
Caution The fault reader must be installed in the rear seat and operated from there. |
|
In order to avoid injury to persons and/or the damage to the pre-heating and injection system the following rules must be observed: |
t
| Detach and connect the wires of the pre-heating and injection system, including the leads of the measurement equipment, only with the ignition off. |
t
| If the engine must be turned over at start-up revs without starting it, for example: to test the compression, remove the injector-pump unit connector from the cylinder head. |
t
| In the case of a radio with anti-theft coding, consult the code before disconnecting the battery. |
t
| The battery may only be disconnected or connected with the ignition off; otherwise, the direct diesel injection system control unit may be damaged. |
|
|
|