Leon Mk1
| Assembly overview |
| 1 - | Oil pressure switch -F1- 0.3 bar -0.7 Nm, 25 Nm |
| 2 - | Guide sleeve |
| 3 - | Oil pump: |
| q | Always replace completely |
| q | removing and fitting → Chapter |
| 4 - | 25 Nm |
| 5 - | Oil pan |
| q | removing and fitting → Chapter |
| q | Clean sealing surface before installing |
| q | Install with silicone sealant D 176 600 A1. |
| 6 - | 9 Nm |
| 7 - | Oil seal |
| q | Replace |
| 8 - | Oil drain plug, 30 Nm |
| q | With safety washer |
| q | Replace |
| 9 - | 8 Nm |
| 10 - | Cover |
| 11 - | 20 Nm + further 1/4 (90°) |
| 12 - | Pinions |
| q | For the oil pump → Item |
| q | Adjust timing after assembly → Chapter |
| 13 - | Drive chain for oil pump |
| q | Before removing, mark direction of rotation (installation position). |
| q | removing and fitting → Chapter |
| 14 - | Chain tensioner with tensioning plate |
| q | Drive chain for operating the oil pump → Item |
| 15 - | 15 Nm |
| 16 - | Pinions |
| q | Drive chain for operating the oil pump → Item |
| 17 - | Mounting bush |
| q | With O-ring |
Note| Always replace the O-ring after dismounting |
| 18 - | Pulley |
| q | Do not tilt during assembly |
| q | Poly-V belt: removing and installing → Chapter |
| 19 - | 150 Nm and then turn 180° further |
| q | Replace |
| q | Lubricate |
| q | Secure pulley with retaining tool -3415- see equivalent → Anchor. |
| q | The turning further angle can be checked using a commercial protractor e.g. Hazet 6690. |
| 20 - | Oil level/oil temperature sender -G266- |
| 21 - | Guide pipe |
| 22 - | Oil dipstick |
| q | Oil level must not be above max. mark on dipstick! |
| q | Marks → Fig. |
| 23 - | 10 Nm |
| 24 - | Oil separator |
| q | With heated vacuum valve |
| 25 - | O ring |
| q | Replace if damaged |
| 26 - | Oil filter, 25 Nm |
| q | Oil filter - Assembly overview → Chapter |
| q | Oil filter cartridge: removing and fitting → Chapter |
| 27 - | 24 Nm |
