SEAT Workshop Service and Repair Manuals

Oil pump: removing and installing t  Removing → Anchor t  Installing → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Extractor -SAT 1100-, see equivalent → Anchor

t	Hose clamp -T10172-, see equivalent → Anchor

t	Torque wrench (5... 50 Nm) -V.A.G 1331-, see equivalent → Anchor

Removing –  Place the oil extractor -SAT 1100- underneath the engine and drain the engine oil.   Note Please observe requirements for disposal. –  Remove sump → Chapter.

–  Hold oil pump chain sprocket with counterhold -T10172-. –  Loosen chain sprocket securing bolt.   Note Do not remove bolt completely.

–  Push the chain tensioner in the -direction of the arrow- using a screwdriver. –  Remove chain sprocket securing bolt. –  Take chain sprocket off oil pump and out of chain.

–  Loosen oil pump securing bolts -arrows- and remove them. –  Remove oil pump from cylinder block. Installing

–  Push the chain tensioner in the -direction of the arrow- using a screwdriver. –  Seat chain sprocket in chain and fit chain sprocket onto oil pump shaft.

–  Observe installation position of chain sprocket on oil pump shaft -arrow-. –  Fit chain sprocket securing bolt. –  Hold chain sprocket with counterhold -T10172-.

–  Place the torque wrench (5...50 Nm) -V.A.G. 1331- as shown. –  Tighten fastening bolt to 20 Nm + 1/4 revolution. (90°) using a spanner. –  Install sump → Chapter. –  Fill with engine oil.