Leon Mk1
Assembly overview - fuel system |
1 - | Air filter |
q | Removing and installing → Chapter. |
2 - | Lambda probe -G39- |
q | 50 Nm |
q | Grease only the threads with „G 052 112 A3“ The „G 052 112 A3“ must not get into the slots on the probe body. |
q | Removing and installing → Chapter. |
3 - | Engine control unit -J623- |
q | Removing and installing → Chapter. |
If the engine control unit -J623- needs to be renewed, connect → Vehicle diagnostic tester and perform „Guided functions, Renewing engine control unit“. |
q | If renewed, adapt engine control unit -J623- to electronic immobiliser → Vehicle diagnostic tester„Guided functions“. |
4 - | Bolt. |
q | 8 Nm |
q | For engine speed sender -G28-. |
5 - | Coolant temperature sender -G62- |
q | Removing and installing → Chapter. |
q | Before removing, release pressure in cooling system if necessary. |
6 - | Lambda after catalytic converter -G130-, 50 Nm |
q | Grease only the threads with „G 052 112 A3“ The „G 052 112 A3“ must not get into the slots on the probe body. |
q | Remove and install with → Chapter. |
7 - | Bolt. |
q | For knock sensor |
q | 20 Nm |
8 - | Knock sensor |
q | Removing and installing → Chapter. |
9 - | Bolt. |
q | 20 Nm |
10 - | Intake manifold |
q | Removing and installing → Chapter. |
11 - | Bolt. |
q | 8 Nm |
q | Quantity 5 units |
12 - | Fuel rail with injectors: |
q | Injector, cylinder 1 -N30- |
q | Injector, cylinder 2 -N31- |
q | Injector, cylinder 3 -N32- |
q | Removing and installing → Chapter. |
13 - | Bolt. |
q | 7 Nm |