Leon Mk1
Removing and installing cylinder head |
Checking compression pressure → Chapter |
Note!
t | When installing an exchange cylinder head with fitted camshaft, the contact surfaces between bucket tappets and the cam must be oiled before installing the cylinder head cover. |
t | The plastic packing pieces for protecting the open valves must not be removed until immediately prior to fitting the cylinder head cover. |
t | When the cylinder head is renewed, the entire coolant in the system must also be renewed. |
t | Removing and installing intake manifold/pipe → Chapter, Removing and installing parts of the injection system |
1 - | Toothed belt guard, upper part |
2 - | Toothed belt |
q | Check for wear |
q | Do not kink |
q | Removing, installing and tensioning → Chapter |
3 - | Bolt |
q | 20 Nm |
4 - | Toothed belt guard, rear |
5 - | Lifting eye |
6 - | Cylinder head cover |
q | Before fitting, coat transition points for bearing cap/cylinder head and the half-moon shaped cut-out with -D 454 300 A3- |
7 - | Bolt |
q | 10 Nm |
q | Loosen and tighten bolts one after the other from inside to outside using alternate and diagonal sequence. |
8 - | Ignition/HT. wiring cover |
9 - | Ignition/HT. wiring guide |
10 - | Cylinder head bolt |
q | Renew |
q | Observe assembly instructions and sequence when loosening and tightening → Chapter |
11 - | Cylinder head |
q | Removing and installing → Chapter |
q | Check for distortion → Fig. |
q | If renewing, renew entire coolant |
12 - | Cylinder head gasket |
q | Renew |
q | Metal gasket |
q | If renewing, renew entire coolant |
|