SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing engine control unit >
< Engine control unit
Leon Mk1
Power unit
4-cylinder diesel engine (1.9 l engine)
Fuel preparation system Diesel injection
Engine control unit
Reading and erasing engine control unit fault memory
Reading and erasing engine control unit fault memory
Reading and erasing engine control unit fault memory
Special tools and workshop equipment required
t
Vehicle diagnosis, testing and information system -VAS 5051-
t
Diagnosis cable -VAS 5051/1- or diagnosis cable -VAS 5051/3-
Procedure
–
Connect vehicle diagnosis, testing and information system -VAS 5051- as follows:
Vehicles ► 05.2000
–
Open ashtray
-3-
.
–
Press ashtray cover
-1-
on both sides in direction of arrows. The ashtray
-2-
springs out slightly and can be removed.
–
Pull open ashtray housing out of centre console.
–
Push diagnosis cable -VAS 5051/1- connector onto diagnosis connector.
Vehicles 06.2000 ►
–
Connect diagnosis cable -VAS 5051/1- or -VAS 5051/3- to diagnosis connector.
Continuation for all vehicles
–
Start engine and run at idling speed.
Only when engine does not start:
–
Switch on ignition.
Selecting operating mode:
–
Press button on display for „Vehicle self-diagnosis“.
Selecting vehicle system:
–
Press button „01 - Engine electronics“ on display.
The control unit identification and coding are indicated on display.
Selecting diagnostic function:
–
Press button „02 - Read fault memory“ on display.
–
If no fault is stored in engine control unit „0 fault detected“ is displayed.
–
If faults are stored in the engine control unit, these are shown one below the other on the display.
–
Press
←
button.
–
Press button „05 - Clear fault memory“ on display.
–
Press function „06-End output“.
Power unit
4-cylinder diesel engine (1.9 l engine)
Fuel preparation system Diesel injection
Engine control unit
Reading and erasing engine control unit fault memory
Removing and installing engine control unit >
< Engine control unit