Leon Mk1
Crankshaft: component overview |
1 - | Bearing shell |
q | For cylinder block with oil groove. |
q | Mark used bearing shells for re-installation but not on bearing surface |
2 - | Drive chain sprocket |
q | removing and fitting → Chapter |
3 - | Bearing shell |
q | For bearing cap without oil groove. |
q | Mark used bearing shells for re-installation but not on bearing surface |
4 - | Thrust washers |
q | For bearing 3. |
q | Different types for cylinder block and bearing cap |
q | Note attachment |
5 - | Bolts |
q | Replace |
q | 65 Nm ± +90° |
6 - | Bearing cap |
q | Bearing cap 1: Pulley side: |
q | Bearing cap 3 with recesses for thrust washers. |
q | Fitting position: Retaining lugs on bearing shells in cylinder block and bearing cap must be on the same side |
7 - | Crankshaft |
q | There should be no needle bearing fitted in the crankshaft on vehicles with manual gearbox; remove the needle bearing if necessary |
q | Measuring axial clearance → Chapter |
q | Measuring radial clearance → Chapter |
q | Crankshaft dimensions → Chapter |
q | With drive spur gear for balance shaft assembly |