Measuring radial clearance of crankshaft |
Special tools and workshop equipment required |
Note t
| Mark used bearing shells for re-installation (but do not mark bearing surface). |
t
| If bearing shells are worn down to nickel layer they must be renewed. |
–
| Remove bearing cap and clean bearing journal. |
–
| Place a length of Plastigage corresponding to the width of the bearing on the bearing journal or in the bearing shell. |
l
| The Plastigage must be positioned in the centre of the bearing shell. |
–
| Fit bearing cap and tighten to 30 Nm. Do not turn crankshaft. |
–
| Remove bearing cap again. |
–
| Compare width of Plastigage with measurement scale. |
|
|
|