Leon Mk1
Assembly overview - oil filter bracket and oil cooler |
1 - | Gasket |
q | Renew |
2 - | 15 Nm + 1/4 turn (90°) further |
q | Renew |
q | First fit upper left and lower right bolts and then tighten all four bolts diagonally. |
3 - | Oil filter bracket |
q | Ensure clearance to adjacent components. |
4 - | Seal |
q | Renew |
5 - | Union, 30 Nm |
6 - | Oil supply line |
q | To turbocharger. |
q | When loosening and tightening, counterhold union. |
q | Removing and installing → Chapter. |
7 - | 0.7 bar oil pressure switch -F1-, 22 Nm |
q | Identification: brown. |
q | If sealing ring is leaking, nip open and renew. |
q | Checking → Chapter. |
8 - | Cap, 25 Nm |
9 - | O-ring |
q | Renew |
10 - | Oil filter element |
q | See note → Chapter. |
q | Observe change intervals. |
11 - | Seal |
q | Renew |
q | Oil before installing. |
q | Fit into lugs on oil cooler. |
12 - | Oil cooler |
q | Ensure clearance to adjacent components. |
q | See note → Chapter. |
q | Coolant hose schematic diagram → Chapter. |
q | Checking oil cooler for leaks → Chapter |
13 - | Seal |
q | Renew |
14 - | Plug, 25 Nm |
15 - | 10 Nm |
16 - | Bracket |
q | For wiring harness and connector for earth connection |