seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Equivalence table according to relevance > < Exhaust gas recirculation system

Leon Mk1

Ignition coils with output stage: removing and fitting
Ignition coils with output stage: removing and fitting
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Extractor -T10094-
  W00-1157
t  Assembly tool -T10118-
Removal:
  W00-1148
–  Fit the extractor -T10094-on the ignition coils with output stage -arrow- as in the illustration.
–  Lightly extract the ignition coils with output stage.
–  Connect the assembly tool -T10118- as shown.
–  Carefully open the connector lock and remove the connector.
Fitting
  N28-0284
–  Fit the extractor -T10094- on the ignition coils with output stage as shown.
–  Push the connector over the ignition coil with output stage until it snaps into place.
–  Insert the ignition coil with output stage in the cylinder head in the -direction of the arrow-.
  N28-0285

Equivalence table according to relevance > < Exhaust gas recirculation system