Leon Mk1
Part I |
1 - | Toothed belt guard upper part |
2 - | Toothed belt |
q | Mark direction of rotation before removing. |
q | Check for wear |
q | Do not kink |
q | Removing, installing and tensioning → Chapter. |
3 - | Idler roller |
4 - | 27 Nm |
5 - | 65 Nm |
q | Use counterhold tool -3036- to loosen and tighten |
6 - | Camshaft pulley |
q | Note installation position: the narrow web of camshaft pulley faces outwards and the TDC No. 1 cylinder marking is visible. |
q | Note position when installing toothed belt → Chapter, removing, installing and tensioning toothed belt. |
7 - | Tensioning roller |
q | Removing, installing and tensioning toothed belts → Chapter |
8 - | Washer |
9 - | Toothed belt tensioner |
q | Removing, installing and tensioning toothed belts → Chapter |
10 - | O-ring |
q | Renew. |
11 - | Coolant pump |
q | Check for ease of movement. |
q | If damaged or leaking, renew complete. |
q | Removing and installing → Chapter. |
12 - | 15 Nm |
13 - | Crankshaft toothed belt pulley |
14 - | 90 Nm + 1/4 turn (90°) further |
q | Renew. |
q | Use counterhold tool -3415- to loosen and tighten |
q | Threads and shoulder must be free of oil and grease. |
q | Turning further can be done in several stages. |
15 - | 20 Nm |
16 - | Toothed belt guard centre part |
17 - | Toothed belt guard lower part |
18 - | 10 Nm |
q | Insert with locking fluid -D 000 600 A2-. |
19 - | Poly V-belt |
q | Mark direction of rotation before removing. |
q | Check for wear |
q | Do not kink |
q | Removing and installing → Chapter. |
20 - | Pulley |
q | For power assisted steering vane pump |
21 - | 25 Nm |
22 - | Belt pulley and vibration damper |
q | Can only be installed in one position |
q | Note position when installing toothed belt → Chapter, removing, installing and tensioning toothed belt. |
23 - | Tensioning device for poly V-belt |
q | Swivel with open-end spanner to relax poly V-belt → Chapter, Removing and installing poly V-belt. |
24 - | 45 Nm |
25 - | Right engine mounting bracket |
q | Removing and installing → Chapter Removing, installing and tensioning toothed belt |